Table of Contents
Advertisement
Chapter 6
Installing and Removing a Shared Port Adapter
SPA Installation and Removal
Figure 6-1
Handling a SPA
Metal carrier
Printed circuit board
SPA Installation and Removal
This section provides step-by-step instructions for installing and removing a SPA in a SIP.
When performing the following procedures, wear a grounding wrist strap to avoid ESD damage to the
Caution
SPA. Some platforms have an ESD connector for attaching the wrist strap. Do not directly touch the
midplane or backplane with your hand or any metal tool.
See
Preventing Electrostatic Discharge Damage, page 4-8
for information about ESD.
Figure 6-2
illustrates how to install and remove a SPA in a SIP.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
6-2
OL-14126-03
Advertisement
Table of Contents
Troubleshooting
