Port Gigabit Ethernet Spa Connectors - Cisco ASR-1000-SIP10 Hardware Installation Manual

Asr 1000 series aggregation services routers sip and spa
Table of Contents

Advertisement

5-Port Gigabit Ethernet SPA Overview
Figure 3-19
1
Table 3-18
Table 3-18
LED Label
A/L
STATUS

5-Port Gigabit Ethernet SPA Connectors

The 5-Port Gigabit Ethernet SPA has five individual fiber-optic receivers that support SFP modules.
Each port can send and receive traffic using the optical fiber connections.
SFP Module Connections
The small form-factor pluggable (SFP) module is an input/output (I/O) device that plugs into the Gigabit
Ethernet optical slots on the 5-Port Gigabit Ethernet SPA, linking the port with a 1000BASE-X
fiber-optic network.
The 5-Port Gigabit Ethernet SPA will only accept the SFP modules listed as supported in this document.
Note
An SFP module check is run every time an SFP module is inserted into the 5-Port Gigabit Ethernet SPA
and only SFP modules that pass this check will be usable by the 5-Port Gigabit Ethernet SPA.
SFP modules exist for technologies other than Gigabit Ethernet and for products other than the 5-Port
Gigabit Ethernet SPA. However, the information in this document pertains only to SFP modules that
plug into the 5-Port Gigabit Ethernet SPA ports.
See the
SFP module options, module specifications, and cabling specifications.
For CWDM and DWDM SFP module specifications, see the
Gigabit Ethernet SPAs" section on page
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
3-22
Chapter 3
5-Port Gigabit Ethernet SPA Faceplate
1
A/L (Active/Link) LED
describes the 5-Port Gigabit Ethernet SPA LEDs.
5-Port Gigabit Ethernet SPA LEDs
Color
Off
Green
Amber
Off
Green
Amber
"SFP Module and Cabling Specifications for Gigabit Ethernet SPAs" section on page 3-25
Overview: Cisco ASR 1000 Series Aggregation Services Routers Shared Port Adapters
STATUS LED
2
State
Meaning
Off
Port is not enabled.
On
Port is enabled and the link is up.
On
Port is enabled and the link is down.
Off
SPA power is off.
On
SPA is ready and operational.
On
SPA power is on and good, and SPA is being configured.
3-29.
"CWDM and DWDM SFP Modules for the
2
for
OL-14126-03

Advertisement

Table of Contents
loading

Table of Contents