Table of Contents
Advertisement
7. Select PPP: Internet, Windows NT Server,
8. Click TCP/IP Settings.
9. Ensure that Obtain an IP address automatically is
This document contains information that is private and Confidential, and is supplied on the express condition that it is not to be
used for any purpose other than the purpose for which it was issued, nor is it to be copied or communicated in whole or in part, to
any third party other than the recipient organization, without the prior written permission of EMS Technologies Canada, Ltd.
Windows 98 (or PPP: Windows 95/98/NT4/2000,
Internet for later versions of Windows) as the Type
of Dial-up Server, and then check the following:
Log on to network
Enable Software compression
TCP/IP
The TCP/IP Properties dialog box appears.
selected, and then click OK.
Note: The remote access must also be
configured to Obtain an IP address
automatically.
If the remote access is configured to a
specific IP address:
•
Select Specify name server
addresses.
•
Type in the required IP address and
Subnet Mask information, and then
click OK.
CONFIDENTIALITY STATEMENT
Copyright © EMS Technologies Canada, Ltd.
User's Guide EMS-MN-1110-10048
45
Advertisement
Table of Contents
Troubleshooting
