Configuring A Terminal Adapter - EMS HSD series User Manual

HSD Aeronautical Transceivers

Configuring a terminal adapter

This section provides basic instructions on how to configure
a terminal adapter.
Various combinations of operating systems, equipment
models, and configurations are possible; therefore, consider
the following procedure as a guideline only.
Important: Ensure that you are using a EURO ISDN
model—
To configure a Terminal Adapter:
1. Select EURO ISDN as your switch type.
2. Select an ISDN protocol. It should be the same at
3. Enter both the Directory Number (DN) and Service
4. Enable the phone ports that you are using, and if
The terminal adapter uses the MSN numbers to identify
outgoing calls, and to recognize and route incoming calls to
the appropriate device.
This document contains information that is private and Confidential, and is supplied on the express condition that it is not to be
used for any purpose other than the purpose for which it was issued, nor is it to be copied or communicated in whole or in part, to
any third party other than the recipient organization, without the prior written permission of EMS Technologies Canada, Ltd.
26
not
a North American model.
both ends of the connection. (Contact your service
provider for the appropriate protocol.)
Provider ID (SPID) provided by your Internet Service
Provider (IPS).
necessary assign each port a Multiple Subscriber
Number (MSN) number. (See Table 2 for default
settings.)
It is possible to have multiple devices on the
ISDN line. Each service type has a MSN
associated with it. The MSN defaults, as
defined in the HSD transceiver channel
card(s), are listed in Table 2 ISDN default
MSN settings.
CONFIDENTIALITY STATEMENT
Copyright © EMS Technologies Canada, Ltd.