EMS HSD series User Manual page 36

HSD Aeronautical Transceivers
To configure a Terminal Adapter
for bonded calls (two-channel systems only):
If the HSD Transceiver has two channel cards, bonded calls
provide the potential for higher throughput. For bonded
calls, configure the terminal adapter and connections to use
Multilink PPP as the protocol.
The following is an example configuration for bonded calls
using a DIVA Terminal Adapter. Other manufacturer's
terminal adapters or if used routers may require different or
more complex configurations to configure the system for
bonded calls.
1. Using Hyperterm, connect to the DIVA T/A
2. Type AT@MENU.
This document contains information that is private and Confidential, and is supplied on the express condition that it is not to be
used for any purpose other than the purpose for which it was issued, nor is it to be copied or communicated in whole or in part, to
any third party other than the recipient organization, without the prior written permission of EMS Technologies Canada, Ltd.
28
The system can only make bonded calls if
both channels are available. If another
device is using one of the B Channels, then
the data call proceeds—but as a single
channel call.
If a bonded call is in progress, (using both B
channels) the system is busy and denies all
other calls until a channel is free.
ISDN modem.
The following screen appears.
CONFIDENTIALITY STATEMENT
Copyright © EMS Technologies Canada, Ltd.