Printronix T4204 User Manual page 42

Chapter 2
Label Rewinding
3. Hook the two stepped tabs of the label rewind bracket onto the two
notches on the top edge of the platen roller assembly's tear-bar plate.
Swing the bracket down. Align the bracket's tabs with the platen's bracket
reference holes and insert them.
4. Secure the bracket with the thumb screw.
5. Remove the label rewind clip from the label rewinder spindle.
6. With the label stock already loaded and the front door open (To load
labels see "Loading Roll Media" on page 29), thread the label stock
around and below the platen roller assembly.
7. Press the FEED key with the printhead closed, as needed, to supply more
label stock or liner.
42
1
2
Legend:
1) Label Rewind Bracket
2) Platen Roller Tear Bar Plate
3) Label Rewinder Spindle
4) Label Rewind Clip
1
Legend:
1) Label Stock/Liner
3
4