Lineprinter Plus P-Series Xq Emulation - Printronix T4204 User Manual

Chapter 3
LinePrinter Plus Emulation

LinePrinter Plus P-Series XQ Emulation

Printer
Protocol
(from page 125)
P-Series XQ
Control Code Define CR
06
Code
6.0 LPI CR = CR*
8.0 LPI* CR = CR + LF
10.3 LPI
Gothic EVFU Select
Typeface
char 02 STX* Enable*
char 03 ETX
Disable
char 09 HT
Control Code 06
Control Code 06 defines the function of ASCII code hex 06 (ACK). You can
select an alternate line spacing of 6, 8 or 10.3 LPI.
Define CR Code
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a Carriage Return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends Line Feeds to the printer.
•
CR = CR. Does not insert an extra Line Feed after each Carriage Return.
•
CR = CR + LF. Inserts an extra Line Feed after each Carriage Return.
The next print position will be print position 1 of the next line.
Auto LF
This option defines the printer action when print data is received past the
forms width setting.
•
Disable. Discards any data past the forms width.
•
Enable. Performs an automatic carriage return and line feed when data is
received past the forms width.
136
Auto LF Define LF
Code
Disable* LF = CR + LF*
Enable LF = LF
Upr. Case Slew Relative
Select
Disable* 1-16 Lines*
Enable 1-15 Lines
* = Factory Default
Compressed Elong/Alt.
Print Font
char 01 SOH* Elng=BS Font=SO*
char 03 ETX Elng=SO Font=BS
char 09 HT