Printronix T4204 User Manual page 196

Chapter 5
Troubleshooting Common Situations
Displayed Message
Correct?
BUFFER OVERFLOW Yes
BUFFER OVERRUN Yes
CONFIG DOES NOT Yes
EXIST/SAVE FIRST
CUTTER FAULT Yes
Check Cutter
EC SOFTWARE FAIL* Yes
See Manual
FILE EXISTS Yes
Enable Overwrite
FILE SYSTEM FULL Yes
Delete Files
FILE SYSTEM FULL Yes
Optimize & Reboot
196
Table 13. LCD Message Troubleshooting
Can
User Explanation
Host sent data after the
printer buffer was full.
(serial interface)
Receive overrun. (serial
interface)
Attempt was made to
Load, Print, Delete or use
a configuration as the
Power-Up Config. when
the configuration was
never saved.
1. Cutter option was not
able to complete a full
cut cycle due to a jam.
2. Cutter PCBA detected
current overload and
opened circuit breaker
on cutter PCBA.
Engine control software
failure.
Attempt was made to
save a file using an
existing stored file name.
Insufficient Flash memory
available to store file.
Insufficient Flash memory
available to store file.
Solution
Check your serial host interface
parameter settings; if
necessary, change them so
they match the settings of the
attached host.
Check your serial host interface
parameter settings; if
necessary, change them so
they match the settings of the
attached host.
Enter the Save Config.
sub-menu of the CONFIG.
CONTROL menu and save the
desired configuration using
configurations 1-8 or a named
config.
1. Clear obstruction from cutter
assembly.
2. Wait a few minutes for cutter
circuit breaker to
automatically reset.
Press CLEAR to clear the
fault message and resume
printing.
Cycle power to the printer.
If problem persists, contact your
authorized service
representative.
Enter the File System sub-menu
of the MAINT/MISC menu and
enable the Overwrite Files
feature to overwrite the existing
file.
Enter the File System sub-menu
of the MAINT/MISC menu. Use
Delete to delete unwanted files.
Enter the File System sub-menu
of the MAINT/MISC menu and
use Optimize & Reboot feature.