Chapter
3
LinePrinter Plus Emulation
LinePrinter Plus P-Series Emulation
Printer
Protocol
(from page 125)
P-Series
Control Code
Control Code
06
08
6.0 LPI
Elongated*
8.0 LPI*
Backspace
10.3 LPI
Select SFCC
EVFU Select
1*
Enable*
(0-7F hex)
Disable
FF Valid at
TOF
Enable*
Disable
Control Code 06
Control Code 06 defines the function of ASCII code hex 06 (ACK). You can
select an alternate line spacing of 6, 8 or 10.3 LPI.
Control Code 08
Control Code 08 defines the function of ASCII code hex 08 (BS). You can
define the code to output an elongated character or a backspace.
Define CR Code
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a Carriage Return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends Line Feeds to the printer.
•
CR = CR. Does not insert an extra Line Feed after each Carriage Return.
•
CR = CR + LF. Inserts an extra Line Feed after each Carriage Return.
The next print position will be print position 1 of the next line.
132
Auto LF
Define CR
Code
CR = CR*
Disable*
CR = CR + LF
Enable
Character Set
Alt. Set 80-9F
Control Code*
(see page 135)
Printable
* = Factory Default
Overstrike
Define LF
Code
Enable*
LF = CR + LF*
Disable
LF = LF
SFCC d
PSeries
Command
Dbl High
Even dot plot*
Normal *
Double high
P3/4/6/9 Compat