Spc Coax Params - Printronix T4204 User Manual

SPC Coax Params

CTHI
(from page 148)
Simp Prot
Conv
SPC Coax
Params
SPC Type
Logical Buf
Size
PTX NI* 960
Avatar Comp
1920*
2560
3440
3564
Translation Tbl PA1
SPC Type
•
Avatar Compatible. This option causes the printer to line wrap at 132
characters despite the current print density allowing more characters per
line.
•
PTX NI (Printronix Non-impact). This option causes the printer to not
line wrap at 132 characters.
Logical Buff Size
Refers to the size of the printer buffer, which should be set the same as the
host screen (buffer) size. If the host screen size is unknown, use 1920.
Image Buff Size
This option refers to the printer base buffer size. This size must be set to a
value greater than or equal to the Logical Buffer Size.
Intervention Req
•
Send to Host. The printer sends a signal to the host computer when the
CANCEL key is pressed or a printer fault or hold mode time-out occurs.
•
Do Not Send. No signal will be sent to the host computer.
Image Buf Size Intervention
Req
4K* Send To Host*
2K Do Not Send
PA2 Buffer Reprint
SPC Coax Params
* = Factory Default
Buffer Print
Disable*
Enable
SPC Null Supp
NL @ MPP+1
Disable* On*
Enable
Off
163