Printronix T4204 User Manual page 36

Chapter 2
Loading Fanfold Media
7. Rotate the media width adjustment tab down and slide it over until it is
flush with the fanfold media. Check the location of the media sensor, and
refer to "Sensor Assembly Horizontal Adjustment" on page 47.
8. Close the printhead by pressing down on both sides of the front of the
printhead assembly.
9. Adjust the label pressure control knob to match the width of the label
stock in use.
2 inches or Less
Greater Than 2 inches
36
Legend:
1) Media Width Adjustment Tab
Pressure Control
Label Width
2 inches
4 inches
1
Knob Settings