Printronix T4204 User Manual page 197

Table 13. LCD Message Troubleshooting (continued)
Displayed Message
FILE SYSTEM FULL Yes
Add Flash
FRAMING ERROR Yes
GAP NOT Yes
DETECTED
Check Media
LABEL PRESENT Yes
Remove Label (see
note)
Can
User Explanation
Correct?
Insufficient Flash memory
available to store file.
Serial framing error.
(serial interface)
Printer is set for
Transmissive or
Reflective sensing, but a
gap, notch, or stripe is not
being detected.
Trans Value is set too low
or Refl Value is set to
high.
1. This is the normal
message when Peel-off
or Tear-off Media
Handling has been
selected.
2. Label detected at front
of the printer by the
Label Taken Sensor.
Label Taken Sensor
gate is in the down, or
enabled, position.
3. Incorrect media
handling method is
selected.
Fault Messages
Solution
Contact your authorized service
representative.
Check your serial host interface
parameter settings. If
necessary, change them so
they match the settings of the
attached host.
1. Check to see that the media
installed matches the media
sensor selected in the Config.
menu.
2. Clean the sensor assembly
and paper path.
3. Perform the Run Calibrate
procedure described in this
manual to improve sensors
ability to detect the media in
use.
4. Manually enter a new Trans
of Refl value in the Calibrate
submenu.
1. Remove the label from the
front of the printer to allow the
next label to print.
2. Change the Media Handling
selection to the correct
option.
3. Select Tear-off Strip or
Continuous to prevent the
printer from stopping for label
removal after each label is
printed.
197