Lineprinter Plus Proprinter Xl Emulation - Printronix T4204 User Manual

Chapter 3
LinePrinter Plus Emulation

LinePrinter Plus Proprinter XL Emulation

Printer
Protocol
(from page 125)
Proprinter XL
Define CR
Code
CR = CR* Enable*
CR = CR + LF Disable
20 CPI
Condensed
Enable*
Disable
Define CR Code
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a Carriage Return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends Line Feeds to the printer.
•
CR = CR. Does not insert an extra Line Feed after each Carriage Return.
•
CR = CR + LF. Inserts an extra Line Feed after each Carriage Return.
Auto LF
This option defines the printer actions when print data is received past the
forms width setting.
•
Enable. Performs an automatic carriage return and line feed when data is
received past the forms width.
•
Disable. Discards any data past the forms width.
Define LF Code
•
LF = LF. Does not perform an automatic carriage return when a line feed
command is received. The next print position will be the current print
position of the next line.
•
LF = CR + LF. Forces an automatic carriage return with each line feed
command received. The next print position is position 1 of the next line.
142
Auto LF Define LF
Code
LF = LF*
LF = CR + LF
* = Factory Default
FF Valid at
Character Set
TOF
Enable* (see page 144)
Disable