Character Set; Sfcc D Command - Printronix T4204 User Manual

Chapter 3
LinePrinter Plus Emulation
Alt. Set 80-9F
Determines whether the printer processes ASCII codes hex 80 through hex
9F as control codes or as printable characters.

Character Set

Specifies a character set as shown in the page 135. To use one of these sets,
choose the desired group heading (such as European Sets) and press
ENTER. Then choose the desired set within that group (such as Roman 8)
and press ENTER. Both the group and the desired set will be starred to
indicate your selection. Character sets are shown in detail in the Character
Sets Reference Manual .

SFCC d Command

•
Even dot plot. This option interprets Speed Command as even dot plot.
•
Double high. This option interprets Speed Command as double high.
Select this option for backward compatibility.
PSeries Dbl High
•
Normal. This normal Double High printing for current and older model
printers.
•
P3/4/6/9 Compat. Where older printers printed two dot rows higher, this
option allows for compatibility by raising the print two dot rows to match
the current models dot row value (two dot rows lower).
FF Valid at TOF
•
Enable. Performs a form feed when the host sends a Form Feed
command and the printer is at the top of form.
•
Disable. Will not perform a form feed when the host sends a Form Feed
command and the printer is at the top of form.
134