Rfid Pgl Commands; Write Tag - Printronix T5000e Series Quick Setup Manual
Printronix, inc. owner manual pilot printer t5000e tm series
Hide thumbs
Also See for T5000e Series:
- Module manual (78 pages) ,
- Quick setup manual (40 pages) ,
- User manual (398 pages)
Table of Contents
Advertisement
Chapter 3
RFID PGL Commands
RFID PGL Commands
Write Tag
Purpose
MODE
Format
RFWRITE;[HEX;][EPC m ;][RF n ;L;][LOCK;]AT p ;[(D) datafield (D)]
56
To program non-incremental data into an RFID tag
(embedded in the smart label).
CREATE
RFWRITE;
The RFID Write Tag command.
HEX;
Optional parameter to indicate that the
text in datafield is in hexadecimal format
and that it will be converted to binary
format.
EPC m ;
Optional parameter to indicate that the
data in datafield should be converted to
an EPC number. When this parameter is
used, the HEX option is automatically
enabled and the data field is limited to a
maximum of 14 digits. The AT parameter
is ignored. The tag is then programmed
as follows:
Bits 0 to 1 are programmed with the
EPC value 0 to 3, specified in m .
Bits 2 to 57 are programmed with the
hexadecimal characters in the data field
(14 maximum). If the data field has less
than 14 hexadecimal characters, zeros
are assumed for the remaining digits.
Bits 58 to 63 are set to zero.
RF n ; L ;
Optional parameter to indicate that this
field has dynamic data. Replace n with a
number ranging from 1 to 512 to identify
the field number of this RFWRITE field.
Replace L with the length of the dynamic
data string. If this option is used, the
Advertisement
Table of Contents
