Label Width - Printronix T5000e Series Quick Setup Manual

Chapter 2
QUICK SETUP Menu

Label Width

The allowable range in inches is 00.1 to the maximum print width of
the printer. The allowable range in millimeters is 2.5 to the
maximum width of the printer.
Ver Image Shift
Specifies the amount to shift an image up (-) or down (+) for precise
positioning on the label. The actual height of the image is not
affected by this parameter. The allowable range is -1.00 inches to
the current Label Length value setting, up to a maximum of 12.80
inches in 0.01 inch increments.
The default value is 0.00 inches.
Hor Image Shift
Specifies the amount to shift an image left (-) or right (+) for precise
positioning on the label. The actual width of the image is not
affected by this parameter. The allowable range is -1.00 through
+1.00 inches in 0.01 inch increments, displayed as xx /100.
The default value is 0.00 inches.
Orientation
Specifies the image orientation to be used when printing the label.
•
FEED
42
Portrait. The default. Portrait refers to vertical page orientation,
where the height of a page is greater than its width. The top
edge of the image is parallel to the leading edge of the media.
The following example is viewed from the front of the printer.
4"
media.
of edge leading
the to parallel
is image
of edge top
Leading Edge
the
6"
the
The