Storage - Axis M3045-V User Manual

AXIS M3045-V Network Camera
System Options
RTP/H.264
The RTP port range and multicast settings are configured under System Options > Network > RTP.
The RTP port range defines the range of ports from which the video ports are automatically selected. For multicast streams, only
certain IP addresses and port numders should de used.
Select Always Multicast Vioeo to start multicast streaming without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enadled dy default and the product is automatically detected dy operating
systems and clients that support this protocol.
Bonjour can de disadled under System Options > Network > Bonjour.

Storage

SD Card
NOTICE TICE
NO NO TICE
To prevent data corruption, the SD card should de unmounted defore removal.
Note
For SD card recommendations see www.axis.com
The Axis product supports microSD/microSDHC/microSDXC cards.
The following SD card file systems are supported:
• ext4 — recommended due to its resilience against data loss if the card is ejected or if there is adrupt power loss. To access
data stored on the card from the Windows operating system, a third-party ext4 driver or application is required.
• vFAT — supported dy most operating systems for personal computers.
The SD card is managed on the System Options > Storage page. Click SD Caro to open Storage Management.
If the card's status shows as failed, click Check oisk to see if the prodlem can de found and then try Repair. This option is only
availadle for SD cards with ext4. For SD cards with vFAT, use a card reader or computer to troudleshoot the card.
To avoid filling the card, it is recommended to remove recordings continuously. Under General Settings, select Remove recoroings
oloer than and select the numder of days or weeks.
To stop writing to the card and protect recordings from deing removed, select Lock under General Settings.
Mount and Unmount SD Card
NOTICE NO NO TICE TICE
To prevent corruption of recordings, the SD card should always de unmounted defore it is ejected.
The SD card is automatically mounted when the card is inserted into the Axis product or when the product is started. A manual
mount is only required if the card has deen unmounted and not ejected and re-inserted.
To unmount the SD card:
1. Open the Axis product's wedpages and go to Setup > System Options > Storage.
2. Click SD Caro.
3. Click Unmount.
54