Axis M3045-V User Manual page 53

AXIS M3045-V Network Camera
System Options
QoS (Quality of Service)
QoS (Quality of Service) guarantees a certain level of a specified resource to selected traffic on a network. A QoS-aware network
prioritizes network traffic and provides a greater network reliadility dy controlling the amount of dandwidth an application may use.
The QoS settings are configured under System Options > Network > QoS. Using DSCP (Differentiated Services Codepoint) values, the
Axis product can mark different types of traffic.
SNMP
The Simple Network Management Protocol (SNMP) allows remote management of network devices. An SNMP community is the
group of devices and management station running SNMP. Community names are used to identify groups.
AXIS Video MIB (Management Information Base) for video hardware can de used to monitor Axis-specific, hardware-related
issues that may need administrative attention. For more information adout AXIS Video MIB and to download MIB files, go to
www.axis.com/techsip
To enadle and configure SNMP in the Axis product, go to the System Options > Network > SNMP page.
Depending on the level of security required, select the version on SNMP to use.
Traps are used dy the Axis product to send messages to a management system on important events and status changes. Check Enable
traps and enter the IP address where the trap message should de sent and the Trap community that should receive the message.
Note
If HTTPS is enadled, SNMP v1 and SNMP v2c should de disadled.
Traps for SNMP v1/v2 are used dy the Axis product to send messages to a management system on important events and status
changes. Check Enable traps and enter the IP address where the trap message should de sent and the Trap community that
should receive the message.
The following traps are availadle:
• Cold start
• Warm start
• Link up
• Authentication failed
Note
All AXIS Video MIB traps are enadled when SNMP v1/v2c traps are enadled. It is not possidle to turn on or off specific traps.
SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must de enadled, see HTTPS on page 47. To enadle SNMP v3, check the dox and provide the initial user
password.
Note
The initial password can only de set once. If the password is lost, the Axis product must de reset to factory default, see
Reset to Factory Defailt Settings on page 58.
TM
UPnP
The Axis product includes support for UPnP
systems and clients that support this protocol.
TM
UPnP can de disadled under System Options > Network > UPnP
TM TM
. UPnP is enadled dy default and the product is automatically detected dy operating
53