Call Settings; Advanced Timer Settings - OpenVox DGW-1004 User Manual

Advanced: Registration Options
Table 4-1-2 Definition of Registration Options
Options
Authentication User
Register Extension
From User
From Domain
Remote Secret
Port
Qualify
Qualify frequency
Frequency
Outbound Proxy

Call Settings

Table 4-1-3 Definition of Call Options
Options Definition
DTMF Mode Set default DTMF Mode for sending DTMF. Default: rfc2833.
Other options: 'info', SIP INFO message (application/ dtmf-relay);
'Inband', Inband audio (require 64kbit codec - alaw, ulaw).
Trust Remote-Party-ID Whether or not the Remote-Party-ID header should be trusted.
Send Remote-Party-ID Whether or not to send the Remote-Party-ID header.
Caller ID Presentation Whether or not to display Caller ID.

Advanced Timer Settings

Table 4-1-4 Definition of Timer Options
Options Definition
Default T1 Timer This timer is used primarily in INVITE transactions. The default for Timer T1 is 500ms or the measured run-trip time
between the gateway and the device if you have qualify=yes for the device.
Definition
A username to use only for registration.
When Gateway registers as a SIP user agent to a SIP proxy (provider), calls from this provider connect to this local
extension.
A username to identify the gateway to this endpoint.
A domain to identify the gateway to this endpoint.
A password which is only used if the gateway registers to the remote side.
The port number the gateway will connect to at this endpoint.
Whether or not to check the endpoint's connection status.
How often, in seconds, to check the endpoint's connection status.
A proxy to which the gateway will send all outbound signaling instead of sending signaling directly to endpoints.