Table of Contents
Advertisement
Idle Bearer Reset
Sets the time in seconds between restart of unused B channels; defaults to 'never'
Period
Display Send
Send/receive ISDN display IE options, the display options are a comma separated list of the following options:
Block:
Do not pass display text data.
Name_ initial:
Use display text in SETUP/CONNECT messages as the party name.
Name_ update:
Use display text in other messages (NOTIFY/FACILITY)for COLP name update.
Name:
Combined name_ initial and name_ update options.
Text:
Pas any unused display text data as an arbitrary display message during a call. Sent text goes out in default to 'name'
Display Receive
Send/receive ISDN display IE options. The display options are a comma separated list of the following options:
Block:
Do not pass display text data.
Name_ initial:
Use display text in SETUP/CONNECT messages as the party name.
Name_ update:
Use display text in other messages (NOTIFY/FACILITY) for COLP name update.
Name:
Combined name_ initial and name_ update options.
Text:
Pas any unused display text data as an arbitrary display message during a call. Sent text goes out in default to 'name'
Overlap Dialing
Enable overlap dialing mode--sending overlap digits.
Allow Progress
Allow inband audio (progress) when a call is DISCONNECT Ted by the end of a PRI
When Call
Released
Out-of-Band
PRI Out of band indications. Enable this to report Busy and congestion on a PRI using out_ of_ band notification. Inband
Indications
indication, as used by the gateway doesn't seem to work with all telcos.
Facility-based
To enable transmission of facility-based ISDN supplementary services (such as caller name form CPE over facility),
ISDN
enable this option. Cannot be changed on a reload.
Supplementary
Services
Exclusive Channel
If you need to override the existing channels selection routine and force all PRI channels to be marked as exclusively
Selection
selected, set this to yes. priexclusive cannot be changed on a reload.
Ignore Remote
If you wish to ignore remote hold indications (and use MOH that is supplied over the B channel) enable this option.
Hold Indications
Block Outbound
Enable if you need to hide just the name and the number for legacy PBX use. Only applies to PRI channels.
Caller ID Name
Wait for Caller ID
Support caller ID on call waiting
Name
SS7
Advertisement
Table of Contents
