Homologation 56 - GAS GAS TXTPRO - 2009 Manual

HOMOLOGATION
The vehicle you have just acquired has been homologated under the directives of the EU and complies with all the
homologation requirements demanded.
Compulsory homologation elements required, among others, when travelling on a public road and to meet
periodical vehicle inspection approval at state controlled plants are listed below.
Among other requirements, all homologation components are identified with a determined and registered mark.
List of elements required:
- Manufacture identification plate
- Catalyzed with with secondary air
- Muffler
- Carburettor jets
- Front and rear turn signals
- License plate holder
- Speedometer
- Electrical installation, homologated lights
- Engine output pinnion and sprocket for a correct transmission gear ratio
- Horn
- Rearview mirror
- Antitheft system
- Antimanipulation plate (125 cc version)
- Air filter restriction; carburettor hood limit (according to model)
Each one of the homologation components must form part of the vehicle and in case of loss, breakage or malfunction
it is recommended that the owner contact his official dealer to correct this problema.
Besides the homologated vehicle you have received a complementary kit for a racing version of this same vehicle.
Be advised that this version is not homologated.
Illustration
-56-
Qty. /bike
1
Available 1
Available 1
Available 1
Available 1
Available 1
Available 1
Available 1
1
Available 1
Available 2
1
1
1