Homologation - GAS GAS ENDURO 4T EC 2014 Owner's Manual

Owner´s manual
Multifunction gauge (Only on certain models and markets)

Homologation

NOTE: This chapter is not valid on XC models.
The vehicle just acquired is a vehicle approved under the EU directives and comply with all the requirements for type-approval.
The components of approval required to ride on public roads and to pass technical legislative inspections, which are detailed below.
The components of type-approval are identified with a determined and registered stamp
Each component of type-approval must be a part of your GAS GAS and in case of breakage, loss or malfunction you must go to your official
GAS GAS service to repair it.
Method 2
Find a totally flat surface. Make a mark on the flank of the tire and the ground.
Advance with the motorcycle until the wheel complete one revolution. Make a
mark on the ground at this point. Measure the distance between the marks of the
ground and convert to millimeters. Use this number as a measure of the wheel cir-
cumference. For greater precision, the driver or an equivalent weight must remain
at the motorcycle during this process.
NOTA: In the same way as in Method 1, if you measure the wheel diameter in
inches, first multiply its diameter by 25.4 to convert it into millimeters. Once con-
verted, follow the instructions under 'quick guide' to complete this process.
Component list
Manufacturer identification plate
Catalyzed exhaust
Homologated Front and Rear sprockets
Carburetor jets
Front and rear turning lights
Plate holder
Speedometer
Electrical equipment, homologated lights
Horn
Rear-view mirror
Anti-theft lock
Air filter restriction
Throttle opening limiter
Amount/moto
1
1
1
1
4
1
1
1
1
2
1
1
1
-24-