Leica LED5000 MCI
The Leica LED5000 MCI (for "Multi Contrast
Illumination") is installed using two screws. For
optimum accessibility, the optics carrier should
be removed during installation (see page 21.)
Constraints
The Leica LED5000 MCI cannot be used together
with the objective nosepiece.
Leica M Series User Manual
Assembly
1. Hold the LED5000 MCI with one hand
and tightly screw the retraining stirrups
on both top holes on the drive housing.
Assembly
2. Connect the CAN-bus cable to either of the
two sockets. (The flat part of the plug must
be facing downwards.)
3. Plug the other end of the cable into one of
the three "CTL2" sockets on the column.
43