Viewing the settings in template mode also modifies the settings tree, showing only the settings categories that contain
editable settings. The effect of applying the template to a typical settings tree view is shown below.
Typical settings tree view without template applied.
Figure 8–5: APPLYING TEMPLATES VIA THE VIEW IN TEMPLATE MODE SETTINGS COMMAND
Use the following procedure to display settings available for editing and settings locked by the template.
Right-click the device in the Online or Offline Window area and apply the template by selecting the Template Mode >
View All Settings option.
Enter the template password then click OK to apply the template.
Once the template has been applied, users will only be able to edit the settings specified by the template, but all settings
will be shown. The effect of applying the template to the phase time overcurrent settings is shown below.
Phase time overcurrent settings window without template applied.
Figure 8–6: APPLYING TEMPLATES VIA THE VIEW ALL SETTINGS COMMAND
e) REMOVING THE SETTINGS TEMPLATE
Once a settings template is removed, it cannot be reapplied and a new settings template needs to be defined before use.
Right-click the device in the Online or Offline Window area and select the Template Mode > Remove Template
Enter the template password and click OK to continue.
Typical settings tree view with template applied via
Template Mode > View In Template Mode
Phase time overcurrent window with template applied via
Template Mode > View All Settings
The template specifies that only the
settings be available.
C30 Controller System
8.2 SETTINGS SECURITY