Group: Pwr Management - ComAp IM-NT-BB Reference Manual

Related FW 3.0
Description This setpoint determines the delay which is used in evaluation of BusR V
unbal protection (threshold for this protection is set by the setpoint
unbal).

12.2.8 Group: Pwr management

12.2.8.1 Setpoint: #Pwr mgmt mode
Group Pwr management
Range [units] ABS(kW), ABS(kVA), REL (%) [-]
Related FW 3.0
Description
ABS (
ABS (
REL (%)
N :
OTE
# sign in the name of this setpoint marks that this setpoint is shared among
all controllers connected by CAN2 bus.
NT
InteliMains , SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
W) The power management is based on actual sum of active
K
power of gen-sets participating in the power management
in particular control group (TotRunPact) and sum of active
nominal power of gen-sets participating in the power
management in particular control group (TotRunPnom).
Setpoints #LoadResStrt X (e.g.
#LoadResStop X (e.g.
values in kW.
VA)
The power management is based on actual sum of
K
apparent power of gen-sets participating in the power
management in particular control group (given by
TotRunPact and total reactive power, S^2 = P^2 + Q^2)
and sum of apparent nominal power of gen-sets
participating in the power management in particular control
group (this value is given for each gen-set as Nomin
current multiplied by GenNomV). Setpoints #LoadResStrt
X (e.g. LoadResStrt
LoadResStop 1) are set in absolute values in kVA.
The power management is based on the relative load, i.e.
ratio active power to nominal power. Setpoints
#%LdResStrt X (e.g.
(e.g. %LdResStop
Minimum allowable relative power reserve is evaluated
from nominal power of all running gen-sets combined in %.
LoadResStrt
LoadResStop 1) are set in absolute
1) and #LoadResStop X (e.g.
%LdResStrt 1) and #%LdResStop X
1) are set in relative values in %.
BusR V
1) and
152