Keysight Technologies FieldFox N9913A Configuration Manual page 7

07 | Keysight | FieldFox Handheld Analyzers - Configuration Guide
FieldFox RF and Microwave (Combination) Analyzer FAQs (continued)
Question
14. Is Spectrum Analyzer Trace
Recording and Playback
standard or an option?
ERTA System Typical Configuration
Item
FieldFox
Power splitter
Type-N(m) to Type-N(m) adapter
Trigger cables
1
RF test cable
RF test cable or adapter
RF jumper cable or adapter
RF jumper cable or adapter
LAN cable
N9910X-825
1. The trigger cables and LAN cables must be at least as long as the separation distance between the two ends of the DUT.
ERTA system diagram
Answer
– Spectrum Analyzer mode (Option 233) does not include Trace Recording and Playback by default. To obtain
this capability in SA mode, Option 236 Interference Analyzer and Spectrogram needs to be purchased.
– RTSA mode (Option 350) does include Trace Recording and Playback by default in RTSA mode.
– Purchasing RTSA mode (Option 350) does not enable Trace Recording and Playback in SA mode (Option 233).
Trace record/playback features
Record and playback spectrum traces
Save trace data with GPS time stamp over time
Record and playback spectrogram data
Frequency mask trigger
* RTSA trace recordings can be recalled and played back in SA mode Spectrogram. This has the added benefit that the
measurements are shown 'slower', making it easier for the human eye to decipher the signal content.
Description/Options
Combo analyzer: required Option 210, 233. Recommended: 235, 307
SA analyzer: required: Option 220, recommended: 235, 307
11667A (Type-N) or 11667B (3.5 mm) or 11667C (2.4 mm)
N9910X-850 (for use with 11667A or Type-N systems)
N9910X-712, SMA(m) to BNC(f)
N9910X-713, SMB(m) to BNC(m)
Connecting FieldFox source port 1 to power splitter input
Connecting power splitter output arm to FieldFox port 2
Power splitter output arm to DUT input
DUT output to FieldFox receiver port 2
LAN cable to connect FieldFoxes directly, or the analyzers must be on the LAN
GPS antenna, recommended. Necessary if Option 307 is ordered.
SA mode
SA & Interference Analyzer
Options 233 and 236
Yes
Yes
Yes
Yes
Quantity
2
1
1
2 of each
Total of 4 cables
1
1
1
1
1
2
RTSA mode
RTSA
Option 350
Yes
Yes
No
*
No