Table of Contents
Advertisement
Hardware Installation Manual
HP Series 6000
Adding Devices
Your mass storage system may come with devices pre-installed, or you may
install them at a later time as upgrade kits. The following instructions should
be followed when adding a new device.
Warning
o
Caution
,
After a SCSI device is installed in the mass storage system,
the mass storage system must be carefully reassembled to
ensure compliance with RFI emission requirements, and to
provide adequate protection against electrical shock and
fire hazards.
The mass storage system has been designed for optimum
performance when using the mass storage devices from
Hewlett-Packard. To ensure that the mass storage system meets
its published performance, regulatory, and safety specifications,
we recommend you use only Hewlett-Packard accessory mass
storage devices.
Preparing to Install a SCSI Device
1.
Shut down (halt) the host computer.
2. Turn off power to both the host computer and the mass storage system.
3. Disconnect the power cord from the mass storage system.
4. Disconnect the SCSI cable from the mass storage system.
5.
If
necessary, remove the mass storage system from its rack or cabinet (see
Figure 1-8).
1·10 Mass Storage System
Advertisement
Table of Contents
