Table of Contents
Advertisement
12
www.aeg.com
• all cooking zones are deactivated,
• you do not set the heat setting after
you activate the hob,
• you spill something or put something
on the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• the hob gets too hot (e.g. when a
saucepan boils dry). Let the cooking
zone cool down before you use the
hob again.
• you use incorrect cookware. The
symbol
zone deactivates automatically after 2
minutes.
• you do not deactivate a cooking zone
or change the heat setting. After
some time
deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
, 1 - 3
4 - 7
8 - 9
10 - 14
5.6 The heat setting
To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct
heat setting.
5.7 Using the cooking zones
Put the cookware on the cross / square
which is on the surface that you cook.
comes on and the cooking
comes on and the hob
The hob deacti-
vates after
6 hours
5 hours
4 hours
1.5 hour
Cover the cross / square fully. Induction
cooking zones adapt to the dimension of
the bottom of the cookware
automatically. You can cook with the
large cookware on two cooking zones at
the same time.
5.8 Bridge function
The function operates when
the pot covers the centres of
the two zones.
This function connects two cooking
zones and they operate as one.
First set the heat setting for one of the
cooking zones.
To activate the function for left / right
cooking zones: touch
change the heat setting touch one of the
left / right control sensors.
To deactivate the function: touch
. The cooking zones operate
independently.
When you use only one cooking zone of
the pair we recommend that you use the
rear cooking zone. Also when you use
large cookware we recommend that you
put it near to the rear cooking zone.
5.9 Automatic Heat Up
Activate this function to get a desired
heat setting in a shorter time. When it is
on, the zone operates on the highest
setting in the beginning and then
continues to cook at the desired heating
setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch
(
comes on).
Immediately touch a desired heat
setting. After 3 seconds
To deactivate the function: change the
heat setting.
5.10 Power function
This function makes more power
available to the induction cooking zones.
/
. To set or
/
comes on.
Advertisement
Table of Contents
