Safety Rules - Upright SL20 Series Service & Parts Manual

Electrocution Hazard
O
2.1 S R
AFETY ULES
U O T A
SE F HE ERIAL
W P :
ORK LATFORM
N
EVER
N
EVER
C
LOSE
N
EVER
N
EVER
L
OOK
D N
O OT
N
EVER
N
EVER
N
EVER
I
NSPECT
N
EVER
N
EVER
N
EVER
A U
FTER SE
U
SING
I
NSTALLATION
SL20
Collision Hazard
Never
This Machine is
platform without checking
not Insulated for overhead obstructions.
PERATION
This aerial work platform is intended to lift persons and his tools as well as the material used for the
job. It is designed for repair and assembly jobs and assignments at overhead workplaces (ceilings,
cranes, roof structures, buildings etc.). All other uses of the aerial work platform are prohibited.
operate the machine without first surveying the work area for surface hazards such as holes, drop-
offs, bumps and debris.
operate the machine if all guardrails are not properly in place and secured with all fasteners properly
torqued. Operating the machine with the door open is prohibited.
door after mounting platform. Dismantling guard rails or door is prohibited.
use ladders or scaffolding on the platform.
attach overhanging loads or increase platform size. Installation of wind force-increasing parts or
altering the machine is prohibited.
up, down and around for overhead obstructions and electrical conductors.
exceed maximum carrying load. Distribute all loads evenly on the platform. See specifications page
for maximum platform load.
operate the machine when wind speeds exceed 45 km/h (28 mph = 12.5 m/sec) beaufort scale 6).
use damaged equipment. (Contact UpRight for instructions.)
modify operating or safety systems. Deactivating safety systems is prohibited.
the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged control cable,
loose wire connections and wheel bolts.
climb down elevating assembly with the platform elevated.
perform service on machine while platform is elevated without blocking elevating assembly.
recharge batteries near sparks or open flame. Batteries that are being charged emit highly explosive
hydrogen gas.
secure the work platform against unauthorized use by turning key switch off and removing key.
the machine as a crane is prohibited.
or use of components or parts that are not provided by UpRight Inc. is prohibited.
Tip Over Hazard
position the elevate or drive elevated on
Never
uneven slopes or soft ground or
elevate the platform unless the
platform is level.
Fall Hazard
sit, stand or
Never
climb on guardrail or
midrail.
Page 2-1