Instructions For Replacing The Lamps; Makrolon Tubes; Starter - ergoline OPEN SUN PILOT EXTREME POWER Operating Instructions Manual

12/2011 1004193-02
5.7

Instructions for replacing the lamps

The UV effect of the lamps and thus the tanning effect decreases over the
course of time. Therefore, the replacement intervals specified in the mainte-
nance plan must be adhered to.
UV filters are utilized in order to control the UV radiation, e.g. the filter panels
on the facial tanner. However, the filter effect decreases over the course of
time. Therefore, the replacement intervals specified in the maintenance plan
must be adhered to.
DANGER!
Fire hazard due to overheated lamps!
Non-approved high pressure lamps can explode. Hot lamp
components can set other parts on fire. People can be killed
or severely injured due to smoke inhalation and fire.
– Only fit the high pressure lamps specified by the manu-
facturer.
– Clean the inside of the device regularly. Dust particles
are flammable!
Replace faulty lamps immediately.
5.7.1

Makrolon tubes

Coloured makrolon tubes can be fitted on the accent lamps. The makrolon
tubes do not have to be changed, merely refitted with the new lamps.
5.7.2

Starter

Replace faulty starters immediately.
You can recognize a faulty starter by the blackened ends of the (UV) low
pressure lamps or when the (UV) low pressure lamps can no longer be
started.
Operating a (UV) low pressure lamp with a faulty starter significantly shortens
its service life. The (UV) low pressure lamp loses power and may begin to
flicker under certain circumstances.
The starters are located in either one of the two lamp sockets or become
visible when the (UV) low pressure lamps are removed.
Cleaning and maintenance
Operating instructions – 37/62