Water Pump Replacement - Cornelius Viper E 2 Flavor Service Manual

Step
1
2
3
4
5
6
7
8
9
W P R
ATER UMP EPLACEMENT
The water pump is located just behind the water filter in the center of the unit. It is mounted on a bracket facing
the rear of the unit. To replace the pump, perform the procedure in Table 48..
Step Action
1
Disconnect power from the unit.
2
Remove the rear cover and the side panels.
3
Disconnect the CO
4
Remove and drain the water supply from the unit.
Disconnect the quick disconnect input and output water lines from the bottom
5
of the pump.
6
Disconnect quick disconnect CO
Remove the four (4) screws and locknuts holding the pump to the mounting
7
bracket.
8
Replace the pump.
9
Reverse the procedure to install the new pump.
© 2008-2016, Cornelius Inc.
Action
Disconnect power from the unit.
Remove the rear cover.
Disconnect the spade clips from the defective capacitor.
Remove the mounting screw from the base of the capacitor.
Replace the capacitor.
Reverse the procedure to install the new capacitor.
Reconnect power to the unit.
Refill the barrel with product. See "Filling a Barrel" on page 32.
When barrel fill is complete, perform a motor calibration. See "Calibrating a
Motor" on page 38.
Figure 45. Rear View of Water Pump
supply from the unit.
2
Table 47.
Table 48.
input from the bottom of the pump.
2
- 55 -
Viper Service Manual
Water Pump
Publication Number: 621260373SER