Water Pump Replacement - Cornelius FRUITISTA 3 Service Manual

Viper Service Manual
W P R
ATER UMP EPLACEMENT
Publication Number: 621360041TBSER
Step
3 Disconnect the spade clips from the defective capacitor.
4 Remove the mounting screw from the base of the capacitor.
5 Replace the capacitor.
6 Reverse the procedure to install the new capacitor.
7 Reconnect power to the unit.
8 Refill the barrel with product. See "Filling a Barrel" on page 28.
9 When barrel fill is complete, perform a motor calibration. See "Calibrating a
Motor" on page 34.
The water pump is located near the rear, center of the unit. It is mounted on a
bracket facing the rear of the unit. To replace the pump, perform the procedure
in Table 47.
Figure 45. Rear View of Water Pump
Step
1 Disconnect power from the unit.
2 Remove the rear cover and the side panels.
3 Disconnect the CO
4 Remove and drain the water supply from the unit.
5 Disconnect the quick disconnect input and output water lines from the bottom
of the pump.
6 Disconnect quick disconnect CO
7 Remove the four (4) screws and locknuts holding the pump to the mounting
bracket.
8 Replace the pump.
9 Reverse the procedure to install the new pump.
- 52 -
Table 46.
Action
Table 47.
Action
supply from the unit.
2
input from the bottom of the pump.
2
Water Pump
© 2010-2011, IMI Cornelius Inc.