Example: Rise Indirect Mode Deployment; Example: Rise Vpc Direct Mode Deployment - Cisco Nexus 7000 Series Configuration Manual

Example: RISE Indirect Mode Deployment

Example: RISE Indirect Mode Deployment
This example shows how to configure a RISE service on the Cisco Nexus Series switch that is connected to
a Citrix Netscaler Application Delivery Controller (ADC) appliance through a Layer 2 network:
switch# configure terminal
switch(config)# port-channel 301
switch(config-if)# switchport
switch(config-if)# switchport mode trunk
switch(config-if)# switchport allowed vlan 10,20,30,40,50,60
switch(config)# ethernet 5/1-2
switch(config-if-range)# channel-group 100
switch(config-if-range)# no shutdown
switch(config)# ethernet 6/1-2
switch(config-if-range)# channel-group 100
switch(config-if-range)# no shutdown
switch(config)# service vlan-group 1 20,30,40
switch(config)# feature rise
switch(config)# service type rise name ns22 mode indirect
switch(config-rise)# vlan 10
switch(config-rise)# ip 3.3.3.22 255.0.0.0
switch(config-rise)# vlan group 22
switch(config-rise)# no shutdown
switch(config-rise)# show module service
switch(config-rise)# attach rise slot 301
rise_ent->rise_ip = 2010101
ipaddr 10.10.10.5
Attaching to RISE 301 ...
To exit type 'exit', to abort type '$.'
Telnet rlogin escape character is '$'.
Trying 10.10.10.5...
Connected to 10.10.10.5.
Escape character is '^]'.
The following sample output from show commands enables you to verify the configuration:
switch(config-rise)# show rise detail
RISE module name: ns22
State: active
Admin state: enabled
Interface: N/A
Mode: indirect
Slot id: 301
Service token: 0x1
Serial number: HE2H81UJ47
SUP IP: 3.101.0.10
RISE IP: 10.10.10.5
VDC id: 1
VLAN: 10
VLAN group: 22
VLAN list: 122,221-224,231-234

Example: RISE vPC Direct Mode Deployment

You configure RISE on the Cisco Nexus switch vPC peer that are indirectly connected to the Citrix Netscaler
Application Delivery Controller (ADC) appliance following the same steps that you use to configure an
indirect mode deployment.
The following sample outputs show that the RISE device is active and operational and is connected using the
vPC deployment mode:
switch# show rise
Name
------------- ---- --- --------------- ------------ ---------
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuration Guide
46
Slot Vdc Rise-Ip
Id Id
State Interface
Configuring RISE