Cisco Nexus 7000 Series Configuration Manual page 44

Configuring RISE in a vPC Indirect Mode Deployment
• Make sure that you are in the correct VDC on the Cisco Nexus switch. To switch VDCs, use the switchto
DETAILED STEPS
Command or Action
Step 1 switch# configure terminal
Step 2 switch(config)# feature rise
Step 3 switch(config)# service
vlan-group group-number
vlan-range
Step 4 switch(config)# service type
rise name service-name mode
indirect
Step 5 switch(config-rise)# vlan
vlan-id
Step 6
switch(config-rise)# ip
ip-address netmask
Step 7 switch(config-rise)# vlan
group vlan-group
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuration Guide
34
vdc command.
Purpose
Enters global configuration mode.
Enables the RISE feature on the Cisco Nexus Series switch.
Creates a VLAN group for the Citrix NetScaler Application Delivery Controller (ADC)
appliance data VLANs on the Cisco Nexus Series switch.
The range for the VLAN group is from 1 to 32, and the range for the configured VLANs
is from 1 to 3967. You can enter the vlan-range using a comma (,), a dash (-), and the
numbers.
Creates a RISE service instance, enters the RISE configuration mode on the Cisco Nexus
Series switch, and specifies that the appliance is indirectly connected to the switch in
order to establish RISE connectivity.
You can enter up to 31 alphanumeric characters for the name of the RISE service instance.
Assigns a VLAN to the Citrix NetScaler Application Delivery Controller (ADC) appliance
that is directly connected to the Cisco Nexus Series switch.
• The range is from 1 to 4094.
• This VLAN controls message communication with the supervisor over the RISE
port channel. The same VLAN can be used for the Citrix NetScaler Application
Delivery Controller (ADC) appliance management VLAN.
• The VLAN ID and SVI interface must be created before the RISE channel can be
established. The IP address of the SVI interface is the supervisor IP address for
Citrix NetScaler Application Delivery Controller (ADC) appliance to communicate
with and send the control messages.
Specifies the IP address of the Citrix NetScaler Application Delivery Controller (ADC)
appliance that is directly connected to the Cisco Nexus Series switch.
This IP address controls message communication with the supervisor over the RISE port
channel. The same IP address can be used for the management IP address of NetScaler
appliance.
Specifies the RISE VLAN group to be used by Citrix NetScaler Application Delivery
Controller (ADC) appliance.
The range is from 1 to 32.
Note The trunk-allowed VLANs on the port channel must include all of the VLANs
in the VLAN group as well as the VLAN for the RISE control VLAN message.
Configuring RISE