Cisco Nexus 7000 Series Configuration Manual page 41

Configuring RISE
• Make sure that you are in the correct VDC on the Cisco Nexus switch. To switch VDCs, use the switchto
DETAILED STEPS
Command or Action
Step 1 switch# configure terminal
Step 2 switch(config)# feature rise
Step 3 switch(config)# service
vlan-group group-number
vlan-range
Step 4 switch(config)# service type rise
name service-name mode vpc
Step 5 switch(config-rise)# vlan vlan-id
Step 6 switch(config-rise)# ip
ip-address netmask
Step 7 switch(config-rise)# vlan group
vlan-group
◦ The number and range of the VLAN group for the ADC appliance
vdc command.
Purpose
Enters global configuration mode.
Enables the RISE feature on the Cisco Nexus Series switch.
Creates a VLAN group for the NetScaler appliance data VLANs on the Cisco Nexus
Series switch.
The range for the VLAN group is from 1 to 32, and the range for the configured VLANs
is from 1 to 3967. You can enter the vlan-range using a comma (,), a dash (-), and the
numbers.
Creates a RISE service instance, enters the RISE configuration mode on the Cisco
Nexus Series switch, and specifies that the appliance is directly connected to the switch
in order to establish RISE connectivity.
You can enter up to 31 alphanumeric characters for the name of the RISE service
instance.
Assigns a VLAN to the NetScaler appliance that is directly connected to the Cisco
Nexus Series switch.
• The range is from 1 to 4094.
• This VLAN controls message communication with the supervisor over the RISE
port channel. The same VLAN can be used for the Citrix Netscaler Application
Delivery Controller (ADC) appliance management VLAN.
• The VLAN ID and SVI interface must be created before the RISE channel can
be established. The IP address of the SVI interface is the supervisor IP address
for Citrix NetScaler Application Delivery Controller (ADC) appliance to
communicate with and send the control messages.
Specifies the IP address of the Citrix NetScaler Application Delivery Controller (ADC)
appliance that is directly connected to the Cisco Nexus 7000 Series switch.
This IP address controls message communication with the supervisor over the RISE
port channel. The same IP address can be used for the management IP address of Citrix
Netscaler Application Delivery Controller (ADC) appliance.
Specifies the RISE VLAN group to be used by Citrix NetScaler Application Delivery
Controller (ADC) appliance.
The range is from 1 to 32.
The trunk-allowed VLANs on the port channel must include all of the VLANs
Note
in the VLAN group as well as the VLAN for the RISE control message.
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuring RISE in a vPC Direct Mode Deployment
Configuration Guide
31