Appliance; Configuring Nsvlan Using The Cli; Configuring Nsvlan Using The Configuration Utility - Cisco Nexus 7000 Series Configuration Manual

Remote integrated service engine for citrix netscaler appliances

Hide thumbs Also See for Nexus 7000 Series:

Table of Contents

Configuring APBR on the Citrix NetScaler Application Delivery Controller (ADC) Appliance

Configuring a NSVLAN on Citrix NetScaler Application Delivery Controller (ADC) Appliance

The NSVLAN is a VLAN to which the NetScaler management IP (NSIP) address's subnet is bound. The NSIP

subnet is available only on interfaces that are associated with NSVLAN. By default, NSVLAN is VLAN1,

but you can designate a different VLAN as NSVLAN. If you designate a different VLAN as an NSVLAN,

you must reboot the Citrix NetScaler Application Delivery Controller (ADC) appliance for the change to take

effect. After the reboot, NSIP subnet traffic is restricted to the new NSVLAN.

Perform only one of the following tasks:

Enter the following commands prompt to configure NSVLAN using the CLI:

Before You Begin

• Create a port channel on the Citrix NetScaler Application Delivery Controller (ADC) appliance and map

• Configure the NS IP address (NSIP) on the appliance.

Step 1

set ns config - nsvlan positive_integer - ifnum interface_name ... [-tagged (YES | NO)]

Note

You must reboot the appliance for the configuration to take effect.

Step 2

(Optional) show ns config

set ns config -nsvlan 300 -ifnum 1/1 1/2 1/3 -tagged NO

save config

Step 3

(Optional) unset ns config -nsvlan

Restores the default configuration.

Before You Begin

• Create a port channel on the Citrix NetScaler Application Delivery Controller (ADC) appliance and map

Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches

Configuration Guide

its physical ports to this port channel.

Configuring Auto Policy-Based Routing

Table of Contents

Troubleshooting