Cisco Nexus 7000 Series Configuration Manual page 72

Verifying the Auto Policy-Based Routing Configuration
The following example is sample partial output from the show rise profile command:
> show rise profile
1) Service Name
Status
Mode
Device Id
Slot Number
VDC Id
vPC Id
SUP IP
VLAN
VLAN Group
ISSU
Interface
To display the auto policy-based routing (APBR) configuration on the Cisco Nexus Series switch and verify
that the APBR policy was added, perform one of the following tasks on the switch:
Command
show access list dynamic
show rise [detail]
show route-map
show service rise auto-pbr ipv4 slot slot
The following example displays dynamic access list matching the Real Server IP addresses:
switch# show access-lists dynamic
Example correct output:
IPV4 ACL _rise-system-acl-172.16.10.5-Vlan1010
IPV4 ACL _rise-system-acl-172.16.11.5-Vlan1011
The following example is sample output from the show rise command:
switch# show rise
Name
--------------- ---- --- --------------- ------------ ---------
MPX
Emu
VPX
APBR Configuration <===
rs ip
--------------- ------- -------- --------------- -------- ---------- -------
100.0.1.1
100.0.1.3
100.0.1.5
The following partial output from the show rise detail command includes all of the APBR entries that were
automatically added to the Cisco Nexus Series switch:
switch# show rise detail
RISE module name: MPX
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuration Guide
62
: NS-rise
: Active
: Indirect
: JAF1429CJLB
: 300
: 1
: 0
: 173.173.1.1
: 3
: 1
: None
: N/A
10 permit tcp 10.10.10.11/32 eq 80 any
20 permit tcp 10.10.10.12/32 eq 80 any
10 permit tcp 10.10.11.11/32 eq 50000 any
Slot Vdc Rise-Ip
Id Id
300 1 10.175.1.11
301 1 100.0.1.4
302 1 100.0.1.6
rs port protocol nhop ip
33275 TCP
64301 TCP
21743 TCP
Purpose
Displays information about the APBR service.
Displays information about the APBR service.
Displays information about the license that is loaded
on the Citrix Netscaler appliance.
Displays the RISE running configuration on the Cisco
Nexus Series switch.
State Interface
active Po10
active N/A
active N/A
rs nhop
100.0.1.2 Vlan100
100.0.1.4 Vlan100
100.0.1.6 Vlan100
Configuring Auto Policy-Based Routing
apbr state slot-id
ADD FAIL 301
ADD DONE 301
ADD DONE 301