Cisco Nexus 7000 Series Configuration Manual page 36

Configuring RISE on the Cisco Nexus Switch
Command or Action
Step 6 switch(config-rise)# ip
ip-address netmask
Step 7 switch(config-rise)# vlan
group vlan-group
Step 8
switch(config-rise)# no
shutdown
Step 9
switch(config-rise)# show
module service
Step 10
switch(config-rise)# attach
rise {slot slot-number | name
name}
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuration Guide
26
Purpose
Citrix NetScaler Application Delivery Controller (ADC) appliance to communicate
with and send the control messages.
Specifies the IP address of the Citrix NetScaler Application Delivery Controller (ADC)
appliance that is directly connected to the Cisco Nexus Series switch.
This IP address controls message communication with the supervisor over the RISE port
channel. The same IP address can be used for the management IP address of NetScaler
appliance.
Specifies the RISE VLAN group to be used by Citrix NetScaler Application Delivery
Controller (ADC) appliance.
The range is from 1 to 32.
The trunk-allowed VLANs on the port channel must include all of the VLANs
Note
in the VLAN group as well as the VLAN for the RISE control VLAN message.
Launches the auto-discovery and bootstrap configuration process. The Citrix NetScaler
Application Delivery Controller (ADC) appliance port channel is created with the RISE
IP address set at the Citrix NetScaler Application Delivery Controller (ADC) appliance.
The Cisco Nexus Series switches associates the NetScaler appliance serial
Note
number with the virtual slot number for this Citrix NetScaler Application
Delivery Controller (ADC) appliance.
Discovery does not start if any required information (such as the port, RISE
Note
VLAN, RISE IP address, or switch virtual interface [SVI] of the RISE VLAN)
is not provided. If the discovery times out, the virtual module is shown in the
inactive state. The show rise command on the switch displays the reason for
discovery failure.
(Optional) Displays the status of the RISE service module on the Cisco Nexus Series
switch. If the RISE service module is operational, the status that is displayed is "active."
(Optional) Connects the Cisco Nexus Series switch to the RISE service module and
generates a RISE session from the switch, which allows Telnet access.
• The slot number range varies based on the valid slot numbers for a particular VDC.
The Cisco Nexus Series switch supports 32 RISE instances per VDC. The slot
number range is as follows:
• From 300 to 331 for VDC 1
• From 332 to 363 for VDC 2
• From 364 to 395 for VDC 3
• From 396 to 427 for VDC 4
• You can enter up to 32 alphanumeric characters for the RISE service module name.
• After you enter the password, you can access the Citrix NetScaler Application
Delivery Controller (ADC) appliance to configure it.
Configuring RISE