Default Settings For Auto Policy-Based Routing; Configuring Auto Policy-Based Routing; Enabling The Rise Feature And Ns Modes - Cisco Nexus 7000 Series Configuration Manual

Configuring Auto Policy-Based Routing

• RISE does not support multiple services with the same RS IP address and port protocol. The only
• The virtual routing and forwarding (VRF) instance of the route to the RS must be the same as for the
• We do not recommend that you make any route changes on the egress interface to the RS. If you do
• Equal Cost Multipath (ECMP) is not supported.

Default Settings for Auto Policy-Based Routing

The following table lists the default settings for the Use Source IP (USIP) option on the Citrix NetScaler
Application Delivery Controller (ADC) appliance:
Table 4: Default APBR Parameters on the Citrix NetScaler Application Delivery Controller (ADC) Appliance
Parameter
USIP
Configuring Auto Policy-Based Routing
This section includes the following topics:

Enabling the RISE Feature and NS Modes

To manually enable the RISE feature and any RISE_APBR NS modes for publishing APBR rules, type the
following commands at the command prompt:
Step 1 (Optional) > enable feature RISE
This step is only required if you did not enable RISE when you configured Cisco RISE with Citrix Netscaler. See the
"Configuring Rise" chapter.
Enables the RISE feature on the appliance.
Step 2 > enable ns mode RISE_APBR
Enables the modes of type RISE_APBR on the Citrix Netscaler.
exception is as follows: Two identical services (with different service names) can be on the active and
standby RISE-enabled appliance, pointing to the same APBR configuration.
client VLAN switch virtual interface (SVI) to which the virtual IP (VIP) address is associated. The VRF
does not need to be the default VRF.
make changes, see the troubleshooting information at
ns-gen-netscaler-wrapper-con.html.
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Default Settings for Auto Policy-Based Routing
http://support.citrix.com/proddocs/topic/netscaler/
Default
Disabled
Configuration Guide
53