Configuring Rise On The Cisco Nexus Switch - Cisco Nexus 7000 Series Configuration Manual

Configuring RISE

Configuring RISE on the Cisco Nexus Switch

Before You Begin
• Enable and configure the Cisco Nexus switches as vPC peers. See the Cisco Nexus Series NX-OS
• Make sure that you are in the correct VDC on the Cisco Nexus switch. To switch VDCs, use the switchto
DETAILED STEPS
Command or Action
Step 1
switch# configure terminal
Step 2
switch(config)# feature rise
Step 3
switch(config)# service
vlan-group group-number
vlan-range
Step 4 switch(config)# service type
rise name service-name mode
indirect
Step 5
switch(config-rise)# vlan
vlan-id
Interfaces Configuration Guide for information. The following parameters must be the same on both
Cisco Nexus switches:
◦ The vPC ID
◦ The name of the RISE service instance
◦ The vPC number of the port channel
◦ The IP address of the Netscaler appliance
◦ The number and range of the VLAN group for the Citrix NetScaler Application Delivery Controller
(ADC) appliance.
vdc command.
Purpose
Enters global configuration mode.
Enables the RISE feature on the Cisco Nexus Series switch.
Creates a VLAN group for the Citrix NetScaler Application Delivery Controller (ADC)
appliance data VLANs on the Cisco Nexus Series switch.
The range for the VLAN group is from 1 to 32, and the range for the configured VLANs
is from 1 to 3967. You can enter the vlan-range using a comma (,), a dash (-), and the
numbers.
Creates a RISE service instance, enters the RISE configuration mode on the Cisco Nexus
Series switch, and specifies that the appliance is indirectly connected to the switch in
order to establish RISE connectivity.
You can enter up to 31 alphanumeric characters for the name of the RISE service instance.
Assigns a VLAN to the Citrix NetScaler Application Delivery Controller (ADC) appliance
that is directly connected to the Cisco Nexus Series switch.
• The range is from 1 to 4094.
• This VLAN controls message communication with the supervisor over the RISE
port channel. The same VLAN can be used for the Citrix NetScaler Application
Delivery Controller (ADC) appliance management VLAN.
• The VLAN ID and SVI interface must be created before the RISE channel can be
established. The IP address of the SVI interface is the supervisor IP address for
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Configuring RISE on the Cisco Nexus Switch
Configuration Guide
25