Guidelines And Limitations For Configuring Rise; Default Settings For Rise - Cisco Nexus 7000 Series Configuration Manual

Configuring RISE

Guidelines and Limitations for Configuring RISE

RISE has the following guidelines and limitations:
• When configuring a route-map or prefix-list that contains RHI routes to be redistributed via OSPF,
• Auto-discovery, bootstrap, and auto port configuration are supported only in the direct connect and vPC
• When the Citrix NetScaler Application Delivery Controller (ADC) appliance is indirectly connected to
• You can create up to 32 RISE services. However, the number of active RISE services that are supported
• Multiple instances of RISE services are supported per VDC.
• VLANs cannot be shared across virtual device contexts (VDCs) in a RISE deployment.
• After the RISE service is enabled on the Cisco Nexus Series switch, a service vlan-group must be created
• Control Plane Policing (CoPP) limits the number of packets that can be handled by a Cisco Nexus Series

Default Settings for RISE

The following table lists the default settings for RISE:
Table 1: Default RISE Parameters on the Cisco Nexus Series Switch
Parameter
RISE mode
CoPP
ensure that the prefix-list is created with the le option. For example, the command form ip prefix-list
list1 seq 10 permit 10.16.4.0/24 le 32 ensures that all RHI routes in the range 10.16.4.1/32 to
10.16.4.254/32 are redistributed via OSPF without the need to create a prefix-list for each RHI route in
the 10.16.4.0/24 subnet. This action should be performed on the Nexus 7000 Series switch after creating
an active RISE service.
direct connect modes. In indirect connect mode, manual configuration is required at each end on the
Cisco Nexus Series switches and the Citrix NetScaler Application Delivery Controller (ADC) appliance
in order to establish control channel connectivity and for the discovery and bootstrap process to occur.
the Cisco Nexus Series switch, the service or management VLAN on the Citrix NetScaler Application
Delivery Controller (ADC) appliance must establish the TCP RISE control channel with the Cisco Nexus
Series switches.
is limited by the Cisco NX-OS software.
and associated to the RISE service to specify the data VLANs to be used on the Citrix NetScaler
Application Delivery Controller (ADC) appliance.
switch at one time. CoPP policies for RISE ports 8000 and 8001 are enabled by default as part of the
(default) CoPP profiles.
Cisco Remote Integrated Service Engine for Citrix NetScaler Appliances and Cisco Nexus 7000 Series Switches
Guidelines and Limitations for Configuring RISE
Default
Disabled
CoPP policies for RISE ports 8000 and 8001 are
enabled by default.
Configuration Guide
17