Save To Key; Restore From Key - MERRICK Genetix Safety, Installation, Operation And Maintenance Manual

Save to Key...

Restore from Key...

In addition, at the bottom of the display there will be various Help messages. For
example if no DNA Key is inserted into the receptacle, the message will read,
"Waiting for DNA Key Insertion"
Upon insertion of a properly formatted key, the message will read,
"DNA Key Inserted", and then,
"Reading Master Page", and then
"Ready"
If a key is inserted that has not been properly formatted, the message will read,
"Error, can't read!"
Note: All DNA Keys must be formatted before they can be used. This is normally done at
the Merrick factory.
Once the "Ready" message is received, you may proceed to one of the options above.
Save to Key
If you select this option from the above menu, you will see a screen warning you that
all data (if any) will be overwritten on the inserted DNA Key. Press the Enter key to
confirm and continue, or the Menu/Esc key to abort, leaving the existing data on the
DNA Key intact.
If you confirm, all of the parameters, settings, and data in the internal memory of the
Genetix GCM will be saved to the key. If successful, the Help message will read,
"Writing Data", and then,
"Successful Save"
Restore from Key
If you select this option from the above menu, you will see a screen warning you that
all data in the Genetix GCM will be overwritten by the data on the present DNA Key.
Note: Once the data is written to the GCM from the DNA Key, the GCM will
automatically be reset, making the new settings effective. This will cause the feeder
to stop (if it was running), and may cause other process related issues. It is strongly
recommended that the Restore operation only be done while the process is stopped
and peripheral devices secured.
Press the Enter key to confirm and continue, or the Menu/Esc key to abort, leaving
the data in the Genetix GCM intact.
Page 95 of 104
↑
↓