Configuration - MERRICK Genetix Safety, Installation, Operation And Maintenance Manual

You may enter the register number you wish to change (upper left corner), and press
the Enter key. Once the register number is entered (299 as shown above), the cursor
will move the current value, allowing you to edit it. In order to do this properly, you will
probably need a list of registers, which can be provided by Merrick if necessary.
Note: Directly entering register values is very risky, as it is possible to enter a value
that will render your Genetix controller inoperative. Again, it is for the advanced user
or Service Technician only.

Configuration

(Main Menu > Advanced Setup > Configuration)
This section allows you to configure the Genetix controller for your specific
application. By enabling or disabling certain features, you can tailor the control to your
feeder and application. Also as you enable or disable features, the User Interface
menu system is re-configured automatically making certain items visible or invisible.
All features are enabled by setting to yes ("Y") or disabled by setting to no ("N").
Selecting this menu item, you will be presented with the following menu:
Page 87 of 104