Logical Outputs; Appendix B - MERRICK Genetix Safety, Installation, Operation And Maintenance Manual

This is a list of all Logical outputs that are available in the Genetix controller.
Note: Its possible some outputs will not be visible, depending on the Configuration
settings (see Main Menu > Advanced Setup > Configuration).
The following Logical outputs are always available, regardless of Configuration
settings.
Name
Warning
Fault
Running
Feeding
Ready
LoadCell 1 Ovl
LoadCell 1 Undl
LoadCell 2 Ovl
LoadCell 2 Undl
LC Ch1 Failure
LC Ch2 Failure
High Belt Load
Low Belt Load
High Belt Speed
Low Belt Speed
High Feedrate
Low Feedrate
Load Imbalance
Zero Track Fail
Belt Slippage
Inferred Load
Inferred Speed
No Belt Motion
Cal in Progress
HeartBeat
Parameter Fail
Port 0 Timeout
Port 1 Timeout
Port 2 Timeout
Expansion Board related. Present when one or more expansion I/O boards are
enabled (see Main Menu > Advanced Setup > Configuration ).
XIO 1 Failure
XIO 2 Failure
XADC Failure
XDC Failure
Page 100 of 104

Appendix B

Logical Outputs

Description
Warning
Fault
Feeder belt is running
There is a feedrate
Feeder is running or startable
Load Cell A/D channel 1 overload
Load Cell A/D channel 1 underload
Load Cell A/D channel 2 overload
Load Cell A/D channel 2 underload
Load cell A/D channel 1 failure
Load cell A/D channel 2 failure
High Belt Load limit
Low Belt Load limit
High Belt Speed limit
Low Belt Speed limit
High Feedrate limit
Low Feedrate limit
Load Cell A/D channels imbalance
Zero Tracking has stepped out of range
The tacho ratio Tac2/Tac1 is outside of its limits
Inferred load used
Inferred speed used
No belt motion was detected. Note, this output always active.
A Calibration procedure is active
Application integrity toggle output
Parameter load at start-up failed or save after change failed
Communications time out, port 0 (USB)
Communications time out, port 1 (UART0)
Communications time out, port 0 (UART1)
Expansion board 1 is enabled and is failing
Expansion board 2 is enabled and is failing
Analog I/O expansion board is enabled and is and is failing.
(Can be either of two Expansion Analog Cards)
Communication board is enabled and is failing