Table of Contents
Advertisement
■
Monitor/viewfinder
The monitor/viewfinder is turned off although the camera is turned on.
• When a hand or an object gets close to the eye sensor, the display mode could be switched from
monitor to viewfinder accidentally. (→54)
Pictures do not show on the monitor.
• Viewfinder display mode is activated.
→ Press [EVF] to switch to the monitor display mode. (→54)
• The monitor is turned off.
→ Press [DISP] to switch the display information. (→62)
• When you connect the camera to a TV using an HDMI micro cable, the picture is not displayed on
the monitor/viewfinder in the following cases.
– During playback
The displayed brightness is unstable.
• The aperture value is set while shutter button is pressed halfway. (This does not affect the recorded
picture.)
This may also occur when the brightness changes because the zoom is operated or the camera is
moved. This is the automatic aperture operation of the camera and is not a malfunction.
The screen flickers indoors.
• The screen may flicker for a few seconds after turning on. This is an operation to correct flicker
caused by lighting such as fluorescent lights, LED lights, etc. and is not a malfunction.
The screen is too bright/too dark.
• Check the [Monitor Luminance] setting. (→45)
• Use [Monitor Display]/[Viewfinder] to adjust the brightness of the screen. (→44)
Black/blue/red/green dots or interference appears. The monitor image looks distorted when
touched.
• This is not a fault, and will not be recorded on the actual pictures.
Noise appears on the monitor/viewfinder.
• In dark places, noise may appear as a result of the signal amplification necessary to maintain the
brightness of the displayed image.
I cannot switch between the monitor and viewfinder when pressing [EVF].
• When connected to a computer or printer, the camera can display pictures on the monitor only.
284
Others
Q&A Troubleshooting
Advertisement
Table of Contents
