Table of Contents
Advertisement
the display will blink. Use DOWN and UP button to select
(display off 20 seconds after exit menu) mode. Once select, press ENTER button to setup or
exit menu mode without any change after one minute. Back to the functions without any change
press MENU button again.
Display Inverse
Press MENU button until
(display normal) or
functions without any change press MENU button.
White Balance
Press the MENU button up to when
use DOWN and UP button to select
and use DOWN and UP button to adjust the value between 125 and 255, once select press ENTER
button to setup or automatically exit menu mode without any change after one minute. To go back
to the last function without any change press the MENU button.
Manual setting color
Press the MENU button up to when
use DOWN and UP button to select
button to confirm and use DOWN and UP button to adjust the value, once select press ENTER
button to setup or automatically exit menu mode without any change after one minute. To go back
to the last function without any change press the MENU button.
Self-Test
Press the MENU button up to when the
button and the unit will run the built-in programmer for self-test. To go back to the functions
press the MENU button.
Temperature Test
Press the MENU button up to when
the display will show the temperature of the unit. To go back to the functions press the MENU
button again.
is blinking on the display. Use DOWN and UP button to select
(display inverse), press ENTER button to setup. Back to the
is shown on the display. Pressing ENTER button, and
,
or
is shown on the display. Pressing ENTER button, and
,
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER button and
9A
(display always on) or
, press ENTER button to confirm
or ... or
(strobe), press ENTER
Advertisement
Table of Contents
