6.2 CONNECT COMPUTER INTERFACE (OPTIONAL)
This UPS is supplied with local monitoring software. If used, connect the computer
interface port and the USB port of the UPS using the supplied cable.
Note: Computer interface connection is optional. The UPS works properly without a
computer interface connection.
CAUTION: Use only factory supplied or authorized UPS monitoring cable!
6.3 CONNECT TO UTILITY
Connect the power cord on the UPS to a properly grounded AC power outlet. Do not use
surge protectors or extension cords. Please notice the voltage of utility power should match
with the UPS. For example, the rating voltage of UPS is 120V, the input utility power
should be the same as 120V.
6.4 CHARGE THE BATTERY
The UPS charges its battery whenever it is connected to utility power. For best results,
charge the battery for 8 hours in the initial use.
6.5 CONNECT THE LOADS (DEVICES)
The employed equipment's power cords (such as computer) are plugged into the sockets
on the rear panel.
CAUTION: Do not plug high-draw equipment such as laser printer or plotter to the "UPS
outlets". A laser printer or plotter periodically draws significantly more power than when it
is in idle status, and may overload the UPS.
Note: The Toshiba UPS is designed to support electronic equipment only. The UPS will be overloaded
if the total VA rating for all equipment connected through the battery backup/surge protection outlets
exceeds the UPS's Output Capacity.
TPX Series UPS 700VA Operational Manual – 97673-000
11