Directed DBALL2 Installation Manual page 4

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 1 - without T-Harness
Refer to the Vehicle Wiring Reference Charts for wire color and location.
Ignition switch
(Connector side view)
6 1
12 7
CUT
1 2 3 4 5
(MUX)
6 7 8 9 10
Parking Lights:
Pin 1
Headlight switch
(black 10-pin conn.)
Connected to the Dodge Journey only. DO NOT connect Parking Light Input to (+)12V at the ignition switch.
[1]
All connectors are displayed from the wire side (unless specified otherwise).
Ignition
Barrel
HS CAN High: Tan/Black: 3
HS CAN Low: Tan: 4
(+) 12V: Brown: 7
Ignition Interrupt (vehicle side): Yellow: 8
Ignition Interrupt (conn. side): Orange/Yellow: 9
(+) 12V: Red: 13
(-) Ground: Black: 14
(-) Parking Light Output: Green/Black: 2
[1]
(MUX) Parking Lights Output: Violet/Green: 8
(MUX) Parking Lights Output: Violet/Brown: 9
(-) RAP Off Output: Yellow/Black: 10
Driver
Kick
Panel
(-) Driver Door
Trigger: Violet
Connect parking
lights in drivers
kick panel for
Dodge Journey only.
This is the only connection required for the
parking light output for the Dodge Journey.
The DBALL MUX connection is not required.
RF
DBALL2
Prog. Button
LED
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
Rev.: 20170214
(+) Parking Lights:
[1]
White/Violet, pin 3
Dodge Journey
(+) Parking Lights
White/Violet
85
86 87
87a
30
+12V
Fuse 15A
ONLY connect for
Dodge Journey.
Hood Pin
Remote Start Safety
Override Switch
6: White/Black: (-) Hood Input
(+) 12V
RX
(-) Ground
TX
© 2017 Directed. All rights reserved.
Page 4