Directed DBALL2 Installation Manual page 15

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 5 - with CHTHD2 (R1-R6 & R9-R10) /THCHD2 (R1) T-Harness
Refer to the Vehicle Wiring Reference Charts for wire color and location.
Drivers kick Drivers kick
harness to rear harness to rear
(+) Parking lights: (+) Parking lights:
White/Violet White/Violet
To vehicle's To vehicle's
(+) Parking Lights (+) Parking Lights
85 85
86 86
87 87
87a 87a
30 30
+12V +12V
Fuse 15A Fuse 15A
(+) 12V (+) 12V
Refer to the Vehicle Refer to the Vehicle
wiring reference chart. wiring reference chart.
Ignition Switch
8-pin Connector 8-pin Connector
(harness side) (harness side)
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
Diagnostic Connector OBDII
(connector side view)
HS CAN High: Orange/Green
HS CAN Low: Orange/Brown
(-) Parking Lights Output: Green/Black
(-) RAP Off Output: Yellow/Black
Driver Door Trigger Driver Door Trigger
Refer to the Vehicle Refer to the Vehicle
wiring reference chart. wiring reference chart.
CHTHD2 (R1-R6 & R9-10)
/ THCHD2 (R1)
(optional)
N.C. N.C.
HS CAN High: Pin 6 HS CAN High: Pin 6
1 1 8 8
9 9 16 16
HS CAN Low: Pin 14 HS CAN Low: Pin 14
RF
DBALL2
Prog. Button
LED
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
8-pin Connector 8-pin Connector
8-pin Connector 8-pin Connector
at ignition switch at ignition switch
(harness side) (harness side)
(Vehicle side) (Vehicle side)
Rev.: 20170214
Page 15
Hood Pin
White/Black
Remote Start Safety
Override Switch
(+) 12V
RX
(-) Ground
TX
© 2017 Directed. All rights reserved.