Directed DBALL2 Installation Manual page 16

Platform: DBALL2
Firmware: CHRYSLER Remote Start Ready (RSR) Installation
Installation Type 5 - without T-Harness
Refer to the Vehicle Wiring Reference Charts for wire color and location.
Drivers kick
harness to rear
(+) Parking Lights
White/ Violet
To vehicle's
(+) Parking Lights
85
86
87
87a
30
+12V
Fuse 15A
(+) 12V
Refer to the Vehicle
wiring reference chart.
Sentry Key Module
(black 8-pin conn.)
1
(-) Ground:
Black/Striped,
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
Diagnostic Connector OBDII
(connector side view)
1
9
HS CAN Low: Orange, pin 14
(-) P.K. Lights Output: Green/Black: 2
(-) RAP Off Output: Yellow/Black: 10
8
(+) 12V: Red or
Black or
Red/Striped, pin 5
pin 4
HS CAN High: Green, pin 6
8
16
FT CAN High: Tan/Black: 3
FT CAN Low: Tan: 4
HS CAN High: Orange/Green: 5
HS CAN Low: Orange/Brown: 6
(+) 12V: Brown: 7
(+) Ignition Output: Yellow: 8
(+) 12V: Brown/Red: 12
(+) 12V: Red: 13
(-) Ground: Black: 14
(MUX) Ign. Output: Violet/Green: 8
(MUX) Ign. Output: Violet/Brown: 9
Driver Door Trigger
Refer to the Vehicle
wiring reference chart.
Remote Start Safety
RF
DBALL2
Prog. Button
LED
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more information.
© 2017 Directed. All rights reserved.
Rev.: 20170214
Page 16
Hood Pin
Override Switch
6: White/Black: (-) Hood